Why is my Tuttnauer Laboratory Equipment leaking at the door?
If your Tuttnauer Laboratory Equipment is leaking at the door, ensure the door is tightened enough and the door gasket is sealing the chamber. If necessary, replace the door gasket.
Why are wraps burned after using Tuttnauer Laboratory Equipment?
To address wraps coming out burned from your Tuttnauer Laboratory Equipment, check if the water sensor is dirty. Also, verify that the wall outlet voltage is not too high and ensure items are not touching the chamber walls or bottom. Load the autoclave according to the instructions.
How to clean a very dirty Tuttnauer 3850EA chamber?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite ™. Very dirty machines may require two cleanings.
Why does Tuttnauer 3850EA Laboratory Equipment take so long to heat up?
If your Tuttnauer Laboratory Equipment takes too long to heat up, clean the air jet and check for proper voltage at the wall outlet.
What to do if spore tests fail in Tuttnauer Laboratory Equipment?
If spore tests are failing or indicator strips are not turning in your Tuttnauer Laboratory Equipment, clean the air jet. Also, make sure the sterilization time and temperature are set correctly, and ensure the autoclave is not too heavily loaded.
Why does Tuttnauer 3850EA Laboratory Equipment printer feed paper constantly?
If the printer on your Tuttnauer Laboratory Equipment gives paper feeds all the time when the machine is switched on, make sure the ‘feed button’ on the printer is not stuck.
How to troubleshoot Tuttnauer Laboratory Equipment machine not responding?
If your Tuttnauer Laboratory Equipment machine isn't responding, verify that the main switch is in the ‘On’ position, the power cord is properly connected to both the machine and the mains, and the circuit breaker hasn't tripped. Also, check the reset button on the cut-out thermostat.
What to do if Tuttnauer Laboratory Equipment process fails during heating stage with a HIGH TEMP message?
If your Tuttnauer Laboratory Equipment process fails while initiating the heating stage and displays a HIGH TEMP message, try changing the setting of the thermostat.
How to clean a very dirty chamber in my Tuttnauer 3850EA Laboratory Equipment?
If the chamber of your Tuttnauer Laboratory Equipment is very dirty, use Chamber Brite ™ to clean the autoclave; very dirty machines may require two cleanings.
What does ‘Low Heat’ mean on my Tuttnauer 3850EA?
If the message ‘Low Heat’ is displayed during heat up on your Tuttnauer Laboratory Equipment, it indicates a bad temperature sensor. If heating elements are remaining on instead of cycling on and off, call for a technician.
Inspect the autoclave upon arrival for any signs of damage.
Details the instrument's warranty coverage for defects in material and workmanship.
Specifies the physical characteristics and acceptable contaminant levels for water used.
Details the program keys and other operational keys on the control panel.
Lists and explains various error messages and safety precautions.
Covers electrical connection requirements, safety relays, and compliance with regulations.
Covers placement of indicators, spore tests, and proper load arrangement.
Guides on initial setup, filling reservoir, and starting the autoclave.
Outlines routine maintenance tasks for daily, weekly, and periodic intervals.
Explains the importance and procedure for cleaning the air jet to prevent failures.
Details the procedure for cleaning the autoclave using Chamber Brite cleaner.
Provides solutions for the machine not responding and 'Low Heat' errors.
Offers solutions for 'Low Water', 'Low Pres', and 'Low Temp' error messages.
Addresses 'High Temp' errors, printer issues, and door leaks.
Solves issues like long heat-up, long exhaust, and clogged strainers.
General| Voltage | 230V |
|---|---|
| Frequency | 50/60 Hz |
| Type | Autoclave |
| Chamber Volume | 85 liters |
| Material | Stainless steel |
| Cycle Time | Varies depending on cycle parameters |
To Next Page
