How to fix a Tuttnauer 3850EA chamber that is not filling?
If the chamber of your Tuttnauer Laboratory Equipment is not filling, check the water level in the reservoir. Also, inspect the bottom of the reservoir for any obstruction blocking the pickup tube. Clean the water sensor and try filling the machine manually using the Manual Inlet key.
Why is the drying cycle taking so long in my Tuttnauer Laboratory Equipment?
If the drying cycle in your Tuttnauer Laboratory Equipment is taking too long, the autoclave may be overloaded. Also, consider replacing the HEPA filter.
Why does the exhaust stage take so long when running a cycle on my Tuttnauer 3850EA Laboratory Equipment?
If you are running a ‘glassware’ program on your Tuttnauer Laboratory Equipment, this is normal. The slow exhaust will take between 15 and 20 minutes.
Why is there a loud noise coming from the reservoir of my Tuttnauer 3850EA?
If there is a loud noise coming from the reservoir of your Tuttnauer Laboratory Equipment, the sterilization temperature might be set too high. The maximum setting is 274ºF (134ºC).
How do I fix a Tuttnauer Laboratory Equipment printer that doesn't print?
If the printer of your Tuttnauer Laboratory Equipment does not print, ensure the paper is inserted in the printer. If the printer prints a test printout, the printer is O.K. and there is a problem with the electronics. Contact your dealer to solve the problem. If the printer does not print the test printout, there is a problem with the printer. Contact your dealer to solve the problem.
Inspect the autoclave upon arrival for any signs of damage.
Details the instrument's warranty coverage for defects in material and workmanship.
Specifies the physical characteristics and acceptable contaminant levels for water used.
Details the program keys and other operational keys on the control panel.
Lists and explains various error messages and safety precautions.
Covers electrical connection requirements, safety relays, and compliance with regulations.
Covers placement of indicators, spore tests, and proper load arrangement.
Guides on initial setup, filling reservoir, and starting the autoclave.
Outlines routine maintenance tasks for daily, weekly, and periodic intervals.
Explains the importance and procedure for cleaning the air jet to prevent failures.
Details the procedure for cleaning the autoclave using Chamber Brite cleaner.
Provides solutions for the machine not responding and 'Low Heat' errors.
Offers solutions for 'Low Water', 'Low Pres', and 'Low Temp' error messages.
Addresses 'High Temp' errors, printer issues, and door leaks.
Solves issues like long heat-up, long exhaust, and clogged strainers.
General| Voltage | 230V |
|---|---|
| Frequency | 50/60 Hz |
| Type | Autoclave |
| Chamber Volume | 85 liters |
| Material | Stainless steel |
| Cycle Time | Varies depending on cycle parameters |
To Next Page
