Page 46 of 83 Pages
6.5.2 Print Rate Sterilization
This subdirectory enables to change the printing rate during
sterilization stage
1. To increase or decrease the digits, press the UP or DOWN
keys.
2. After changing the value move the cursor to Set by pressing
the START/STOP.
3. When Set is blinking, press the UP or DOWN keys in order
to confirm changes and return to the previous screen.
4. In order to exit this screen follows one of the next:
In order to exit this screen move the cursor to Exit with
the
START/STOP key and select it by pressing the UP
or DOWN keys.
Press the UP and DOWN keys simultaneously.
To Next Page
Loading...
