To Next PageTo Next PageWhat to do if the display is not activated on my Tuttnauer Medical Equipment?
If the display is not activated, first verify that the main switch is in the ‘On’ position. Next, make sure the power cord is properly connected to both the machine and the power source. Finally, verify that there is electrical power in the main source.
Why is my Tuttnauer Medical Equipment printer not printing?
If the printer is not printing, ensure that the paper is correctly inserted into the printer. If that doesn't resolve the issue, try switching the machine off and then back on. If the printer then prints the date and time, the printer itself is working correctly.
General| Type | Tabletop Autoclave |
|---|---|
| Chamber Volume | 11 liters |
| Voltage | 230 V |
| Frequency | 50/60 Hz |
| Sterilization Temperature Range | 121°C - 134°C (250°F - 273°F) |
| Chamber Material | Stainless Steel |
| Programs | Pre-set and customizable programs |
Provides essential safety guidelines and precautions for operating the autoclave.
Instructions for safely placing, lifting, unpacking, and preparing the autoclave.
Details the required power supply and electrical connections for the autoclave.
Defines the environmental conditions and usage restrictions for the autoclave.
Lists the technical specifications, dimensions, and load capacities of the autoclave.
Specifies the physical characteristics and contaminant levels for acceptable water.
Lists error codes, their messages, and recommended corrective actions for troubleshooting.
Lists the available sterilization programs and test programs offered by the autoclave.
Describes the Bowie & Dick test program, its parameters, and operation sequence.
Details the Vacuum Test program, its procedure, nominal parameters, and notes.
Guidelines for cleaning and preparing instruments and materials for sterilization.
Step-by-step guide on how to fill the autoclave's mineral-free water reservoir.
How to choose and verify the desired sterilization program.
Procedure for safely unloading items and verifying sterilization results.
Overview of maintenance tasks to keep the autoclave in good working condition.
Scheduled maintenance tasks by operator and technician at specific intervals.
Procedure to follow if the autoclave door needs to be opened without power.
Lists common problems with the display and printer and their solutions.
