To Next PageTo Next PageWhy is the chamber not filling in my Tuttnauer EZ9?
If the chamber is not filling in your Tuttnauer Laboratory Equipment, check the water level in the reservoir and look for any obstruction at the bottom of the reservoir blocking the pickup tube. Clean the water sensor. You can also try filling the machine manually using the Manual Inlet key.
Why do wrapped items come out wet from my Tuttnauer Laboratory Equipment?
If wrapped items come out wet from your Tuttnauer Laboratory Equipment, the drying cycle may be too short, or the autoclave may be overloaded. Additionally, the chamber strainer or the HEPA filter may be clogged.
Why does my Tuttnauer Laboratory Equipment autoclave take too long to heat up?
If your Tuttnauer Laboratory Equipment autoclave takes too long to heat up, clean the air jet and check for proper voltage at the wall outlet.
How to unclog the drain in my Tuttnauer Laboratory Equipment?
To unclog the drain in your Tuttnauer Laboratory Equipment, open the drain by turning it counterclockwise. Place a heavy object over the reservoir cover. Blow compressed air into the drain to force any debris back into the reservoir, and then clean out the reservoir. Alternatively, disassemble the drain valve by turning it counterclockwise past the stop point. Remove the valve, clean it, and blow out the line as needed. Reassemble the valve by turning clockwise, ensuring the large “O” ring is pressed into the groove on the autoclave.
Why is my Tuttnauer EZ9 Laboratory Equipment leaking at the door?
If your Tuttnauer Laboratory Equipment is leaking at the door, make sure the door is tightened enough and the door gasket is sealing the chamber. Replace the door gasket if necessary.
What to do if my Tuttnauer Laboratory Equipment is not responding?
If your Tuttnauer Laboratory Equipment is not responding, ensure the main switch is in the ‘On’ position and the power cord is properly connected to both the machine and the mains. Also, check the reset button on the cut-out thermostat and make sure the circuit breaker hasn't tripped by lifting the circuit breaker lever.
How to clean very dirty trays and rack in my Tuttnauer EZ9 Laboratory Equipment?
To clean very dirty trays and racks in your Tuttnauer Laboratory Equipment, remove the trays and rack and clean as per instructions.
How to clean a very dirty chamber in my Tuttnauer EZ9?
To clean a very dirty chamber in your Tuttnauer Laboratory Equipment, use Chamber Brite™. Very dirty machines may require two cleanings.
What to do if my Tuttnauer Laboratory Equipment displays ‘Low Heat’?
If your Tuttnauer Laboratory Equipment displays ‘Low Heat’ during heat up, it indicates a bad temperature sensor. It could also mean the heating elements are remaining on instead of cycling on and off. In either case, call for a technician.
What to do if water does not exit chamber of my Tuttnauer EZ9 Laboratory Equipment due to clogged outlet strainer?
If water does not exit the chamber of your Tuttnauer Laboratory Equipment due to a clogged outlet strainer, clean the strainer according to instructions.
Checks for damage to the shipping carton and autoclave upon receiving the unit.
Specifies physical characteristics and acceptable contaminant levels for water.
Details the functions of program keys, other keys, and their operation.
Details settings and operations for sterilizing unwrapped instruments.
Details settings and operations for wrapped instruments and porous loads.
Details settings and operations for sterilizing glassware with slow exhaust.
Covers electrical connection requirements, safety relays, and grounding.
Outlines daily, weekly, and periodic maintenance tasks for optimal performance.
Procedure for cleaning the air jet to ensure proper sterilization.
Procedure for cleaning the autoclave chamber using Chamber Brite.
Solutions for unresponsive machine, power connection, circuit breakers, and thermostats.
Troubleshooting common error messages like 'Low Heat', 'Low Water', 'High Temp', etc.
General| Brand | Tuttnauer |
|---|---|
| Model | EZ9 |
| Category | Laboratory Equipment |
| Language | English |
