TVS electronics RP-4150 - SELECTING PRINTER PAPER TYPE; Procedure for Paper Type Selection

Mark
MarkMark
Mark Item
ItemItem
Item Dimensions
DimensionsDimensions
Dimensions
A Right edge of black mark 15 or more
B Left edge of black mark 0 to 1.5
C Black mark height 5
D Cut position in black mark 2.5
E Top margin 6.5 / 12
F Black mark pitch 30 to 300
G
Bottom margin
9
5.4 Selecting Paper Type
5.4 Selecting Paper Type5.4 Selecting Paper Type
5.4 Selecting Paper Type
*L, *M
*L, *M*L, *M
*L, *M
Paper type selection is available by the combination of memory switches SW4-
4 and SW4-5 by the used of “ Memory Switch Select Mode” . In addtion, the
following procedure is available.
1 Enter Selecting Paper Type mode.
1 Enter Selecting Paper Type mode.1 Enter Selecting Paper Type mode.
1 Enter Selecting Paper Type mode.
1)Open the printer cover and remove paper. Pressing and holding the
FEED
FEED FEED
FEED button
buttonbutton
button, turn the printer power ON. The POWER LED starts blinking.
2)Release the FEED button
FEED buttonFEED button
FEED button and then close the printer cover. Buzzer sounds
and the paper type currently set is indicated by the LED on the operation
panel.
2 Select Paper Type.
2 Select Paper Type.2 Select Paper Type.
2 Select Paper Type.
Press the FEE
FEEFEE
FEED button
D buttonD button
D button to match the paper type loaded to the LED indications
in the table below. (Refer to the table below.)
3 Save the selected Paper Type to the Printer.
3 Save the selected Paper Type to the Printer.3 Save the selected Paper Type to the Printer.
3 Save the selected Paper Type to the Printer.
Open and close the printer cover. By this operation, selected paper type is
stored in the printer memory and the Selecting Paper Type mode is terminated.
Since then, "P.Length Set" of Memory switch 4-1 becomes disable.
When closing the printer cover during the setting a Black Mark paper or label
paper in the printer, paper length is measured, and the result will be printed
out.
* If Paper Detection error occurs at the measurement of paper length, the
printer automatically enters Adjusting Paper Sensor mode. Adjust the
sensor in accordance with “ 5-5 Adjusting Paper Sensor” .
5.5 Adjusting Pa
5.5 Adjusting Pa5.5 Adjusting Pa
5.5 Adjusting Paper Sensor
per Sensorper Sensor
per Sensor
*L, *M
*L, *M*L, *M
*L, *M
Before using Black Mark paper (BM paper) or label, adjust the Paper sensor.
First, hold the lever at the upper end of the sensor adjustment control cover
located at the left of the Power switch and press the lever down and toward the
front to remove the cover from the printer.
As shown below, the most left one is a label paper sensor adjuster, the next is
Black Mark paper sensor adjuster, and the right one is a level indicator LED.
Adjust them in the following procedure.
— 32 —