EasyManua.ls Logo

TVS Radeon - SELF-MAINTENANCE PROCEDURES; Battery & Fuse Maintenance

TVS Radeon
70 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
SELF - MAINTENANCE PROCEDURES
MAINTENANCE FREE (MF) BATTERY
Battery is located below the cover frame L. Battery
removing procedure are as follows:
1. Place the vehicle on center stand on a flat surface
and open the cover frame L as explained in page
no. 21.
2. Check the battery voltage as per the schedule.
If the voltage measured is less than 12.4
Volts, charge the battery using recommended
MF battery charger at TVS Motor Company
Authorised Main Dealer / Authorised Dealer.
3. Adding any additional electrical accessories
other than TVS recommended ones may lead to
disqualification of warranty coverage.
4. While connecting the terminals observe the
correct polarity. Connect the red wire to the ‘+’
terminal and black wire to the ‘—’ terminal of
battery.
Incase of any abnormality or for removal of battery
from the vehicle, contact TVS Motor Company
Authorised Main Dealer or Authorised Dealer.
Never check the battery charger by shorting the
terminals.
Always connect the positive terminal first (red wire) and
then negative (black wire) to avoid sparking.
Inversion of the battery wires can damage the battery
and the recharging system.

Table of Contents

Related product manuals