34
FUSE
Non-working of electrical systems may be due to
safety fuse failure. Short circuit or overload in the
electrical system are the main causes for fuse failure.
Follow the procedure given below for inspecting and
replacing the fuse.
1. Open the cover frame L as explained earlier (refer
page no. 21).
2. The fuse case fitted near the battery contains a
10A fuse 2 numbers and a 15A fuse.
3. Open the fuse and pull out the required fuse.
4. Replace the fuse with a new (extra fuses are
provided inside the fuse case itself).
5. Close the fuse case and re-fix it into the battery
band.
6. Turn ‘ON’ the ignition switch and check for proper
functioning of electrical systems. Incase the
fuse fails again, consult the nearest TVS Motor
Company Authorised Main Dealer / Authorised
Dealer.
Do not use vehicle by shorting the wires without
fuse. This may result in overheating of electrical items /
wiring and may result in fire.
Do not use fuse of higher amperage than specified for
the safety of electrical system.
To Next Page
Loading...
