TYAN S5515 - Page 77

http://www.tyan.com
77
Recovery Progress Codes
0xF0 Recovery condition triggered by firmware (Auto recovery)
0xF1 Recovery condition triggered by user (forced recovery)
0xF2 Recovery process started
0xF3 Recovery firmware image is found.
0xF4 Recovery firmware image is loaded.
0xF5 – 0xF7 Reserved for future AMI progress codes
Recovery Error Codes
0xF8 Recovery PPI is not available.
0xF9 Recovery capsule is not found.
0xFA Invalid recovery capsule
0xFB – 0xFF Reserved for future AMI error codes
PEI Beep Codes
# of Beeps Description
1 (repeatedly) Memory not installed
1 Memory was installed twice (installPEIMemory routine in PEI Core called twice).
2 Recovery started
3 DXEIPL was not found.
3 DXE Core Firmware Volume was not found.
4 Recovery failed
4 S3 Resume failed
7 Reset PPI is not available.
DXE Phase
Status Code Description
0x60 DXE Core is started.
0x61 NVRAM initialization
0x62 Installation of the South Bridge Runtime Services
0x63 CPU DXE initialization is started.
0x64 CPU DXE initialization (CPU module specific)
0x65 CPU DXE initialization (CPU module specific)
0x66 CPU DXE initialization (CPU module specific)
0x67 CPU DXE initialization (CPU module specific)
0x68 PCI host bridge initialization
0x69 North Bridge DXE initialization is started.
0x6A North Bridge DXE SMM initialization is started.
0x6B North Bridge DXE initialization (North Bridge module specific)