http://www.tyan.com
63
Flow Control
Flow Control can prevent data loss from buffer overflow. When sending data, if the
receiving buffers are full, a ‘stop’ signal can be sent to stop the data flow. Once the
buffers are empty, a ‘start’ signal can be sent to restart the flow. Hardware flow
control uses two wires to send start/stop signal.
None / Hardware RTS/CTS / Software Xon/Xoff
Data Bits EMS / Parity EMS / Stop Bits EMS
Read only.
3.3.4 PCIe Device Configuration
Option ROM Dispatch Policy
Option ROM Dispatch Policy settings.
To Next Page
Loading...
