Tyco TST-100 - Updating TST-100 Touchscreen Terminal firmware; Updating the firmware from C•CURE 9000

Updating TST-100 Touchscreen Terminal firmware
You can update the TST-100 Touchscreen Terminal firmware through C•CURE 9000 or by using a laptop directly connected to
the reader. Read the TST-100 Touchscreen Terminal firmware release notes before updating the firmware.
NOTE
Firmware updates have not been evaluated by UL.
Updating the firmware from C•CURE 9000
Firmware updates completed through C•CURE 9000 are supported on the following controllers connected to an IP-ACM:
• iSTAR Ultra
• iSTAR Ultra SE (in Ultra mode)
• iSTAR Ultra Video
• iSTAR Ultra LT (future release)This procedure updates the firmware on all TST-100 Touchscreen Terminals connected
to the iSTAR.
NOTE
C•CURE 9000 only updates readers using the Smart mode protocol. It does not update readers using the RM mode protocol.
Updating the firmware from C•CURE 9000
1. Copy the TST-100 Touchscreen Terminal firmware files to Program Files (x86)
\Tyco\CrossFire\ServerComponents\istar\ICU\Firmware\Reader.
2. Right-click on the iSTAR controller in the hardware tree, dynamic view, or the status list in the Monitoring Station and
select Update Firmware from the context menu.
NOTE
Update Firmware does not appear on the context menu if the iSTAR is not enabled or is off-line.
3. Select Touchscreen Reader from the Download Type drop-down menu.
NOTE
Touchscreen Reader only appears on the drop-down menu if there are Smart mode TST-100 Touchscreen Terminal readers
configured on the panel.
4. Select the firmware version that you want to download from the list in the dialog box.
5. Click Start firmware download.
A progress bar indicates the firmware download to the controller is complete.
6. When the download has completed, click Close to close the dialog box.
After the download is successful, the controller updates all Smart mode TST-100 Touchscreen Terminal readers connected to
the controller, if needed.
You can verify the TST-100 Touchscreen Terminal reader firmware update in the iSTARReader editor Status tab.
TST-100 Touchscreen Terminal Installation Guide 21