TYM T233 HST - Page 95

4) HST REASSEMBLY
Fig.5
-
16
Reassemble them in reverse order of disassembly in accordance with the following
instruction.
- Installation of clutch damper and related parts.
(1) When installing the clutch damper on the flywheel, be sure to install bolts to flywheel.
(2) Apply a thin coat of molybdenum disulfide-based grease(Three bond TB1901 or equivalent)
to revolving or sliding parts prior to reassembly.
(3) When installing the clutch damper on the flywheel, take care not to damage this clutch damper.
(4) Apply an ANTI RUST 720S or equivalent after installing clutch damper in order to prevent
from rust.
5-10
Fig.5
-
16