TYM T254NC - Roll Over Protective Structures (ROPS); ROPS Safety and Dangers

(ROPS) Roll Over Protective Structures
► ROLL OVER PROTECTIVE STRUCTURES (ROPS)
TYM Tractors are equipped with a frame that protects its operator.
The frame is incorporated in the cab structure in the case of cab tractors.
The objective of the frame or cab structure is to protect the operator in the event of a roll over and to
support the entire weight of the tractor.
Each TYM ROPS frame or cab structure, as well as all mounting bases and bolts or other
fasteners, is designed and has been tested to meet industry and or government standards.
DANGER
For ROPS frames to protect the operator effectively, the provided seat belt must be
worn in order to keep the operator within the ROPS protected area in the event of a roll over.
Failure to use the seat belt can cause serious injury or death.
On some models the ROPS frame has a fold down feature, which can be used to enter low
buildings etc.
Take care when lowering the upper section of the ROPS frame and take extreme care while
driving the tractor with the ROPS frame lowered.
Do not wear the seat belt with the ROPS lowered, and please remember that the fold down facility
is for special circumstances only and no for general use.
Use of the tractor with the ROPS lowered can cause fatal injuries.
As the ROPS frame or cab together with the seat belt was designed to meet certain standards,
they must be maintained in good order and condition.
To achieve this objective, both the structure and the seat belt should be inspected on a regular
basis (every time the tractor is serviced).
In the event that the seat belt is damaged or frayed, it should be replaced, and in the event that the
ROPS frame or any part of the mounting structure is damaged or cracked, the faulty component
must be replaced with a new unit.
Any replacement unit must meet all of the test criteria of the original unit.
Fitment of an inferior item or items affects the certification of the entire ROPS structure and the
effectiveness of the structure in the event of an accident.
Drilling or welding the ROPS structure is forbidden.
14