► CHANGING THE COOLANT
(1) Open to drain cock.
(2) Open the radiator at the same time.
(3) To give a thorough clean, run a hose into the radiator and flush it out.
(4) Close the tap and refill the radiator with a coolant mixture of water and corrosion inhibitor
or anti freeze.
(5) Start the engine and allow it to run for approx 5 minutes, check the water level again and top off
if required.
Do not remove the radiator cap on a hot engine.
Allow the engine to cool down and then turn the cap slowly to ensure that
there is no excessive pressure in the radiator.
Caution
Serious burns can result from the contents of pressurized, hot radiators.
Allow the engine to cool down completely before opening the radiator.
Caution
► ENGINE OIL FILTER CARTRIDGE
Remove the filter with a filter wrench.
To replace, apply oil or grease on the seal, fit by
hand until the seal contacts, then turn it by a 2/3
rd
turn
further to tighten it; check for leaks.
66
Engine Oil Gauge
Engine Oil Filter
To Next Page
Loading...
