TYM T254NC - Front Wheel Drive Lever (4 WD); Drivers Seat Adjustment; Safety Switch Operation; Seat Belt Usage

► FRONT WHEEL DRIVE LEVER (4WD)
Front wheel drive lever is located below the
LHS of the Operator.
In the ON position the front wheels are engaged and
in the OFF position they are disengaged.
Engage or disengage the front wheel drive with the
front wheels in the straight position and at low
speed.
Do not use front wheel drive at high speed or on the road as
premature wear of components will result.
The use of front wheel drive improves traction performance.
■ SEAT BELT
-Releasing the Seat Belt
Press button (C) and Pull the Male Fitting (A) from the Buckle (B).
-Adjusting the Seat Belt
Make Sure the belt is across your hip and not over your stomach.
To adjust the male fitting (A):
1. Pull the toggle (D) down the strap by the required distance.
a. To make the strap longer, pull the end (E) as far as it can go.
b. To make the strap shorter, pull the end (F) as far as it can go.
■ OPERATING THE SAFETY SWITCH
If you do not sit on the your seat while operating the tractor,
the engine will turn off.
► DRIVER’S SEAT
To adjust the seat backwards and forwards, lift the lever at
the front of the seat and set it to the desired position (Please refer to page 16 of how to adjust the seat)
Important
43
Front wheel Driver Lever
(4WD Lever)