■ BLEEDING THE FUEL SYSTEM
1. Fuel filter cock 「ON」
2. Open the cock on the fuel injection pump
3. Fill the tank with fuel and turn on the ignition key.
4. Start the engine and allow it to run for a while
5. Close the fuel injection pump cock.
6. The bleeding of the system is now finished.
■ CLEANING THE FUEL FILTER
1. Close the fuel cock.
2. Remove the fuel filter element.
3. Wash the fuel filter element in clean diesel fuel.
If necessary, replace it.
4. Fit a cleaned or new fuel filter element.
5. Open the fuel cock.
6. Bleed the fuel system
Never use petrol, thinners or any other similar flammable material to clean the
fuel filter.
①
Important
63
②
Fuel Filter Element
■ CLEANING OIL WATER SEPARATOR
If any foreign material or water is
seen through the sight glass, remove
it by performing the following steps
1. Prepare a container to collect fuel
from the oil water separator.
2. Open the drain plug.
3. After a sufficient amount of fuel
is drained, tighten the drain plug with a hand.
4. Do not use any tool.
Fuel Filter Cock
To Next Page
Loading...
