TYM T254NC - Hydraulic System Operation; Hitch Control Lever; Lowering Speed Control Knob

► LOWERING THE SPEED CONTROL KNOB FOR THE 3 POINT HITCH
This knob controls the downward speed of the three point linkage of
Hydraulic and is located below the seat.
After finishing the work, always lower the implement to the ground and switch off
the engine, set the parking brake to avoid injuries and accidents.
► OPERATING THE HYDRAULICS
The hydraulics are powered with an engine driven hydraulic pump and controlled with a position
control lever mounted beside the driver.
► HITCH CONTROL LEVER
The hitch control lever is used to raise or lower the implement mounted to the three point hitch.
To raise the hitch, move the lever to the rear.
To lower the hitch, move the lever forward.
Adjustable stops are provided for use
whenever it is desirable to return the
hitch control lever to
The same operating position.
To slow the downward speed, turn the knob clockwise.
To increase the downward speed, turn the knob counter clock-wise.
To lock, turn the knob clockwise;
Do not over tighten the knob.
Warning
46
HITCH CONTROL LEVER
RISE
LOWER