U-Line CLR60 User Manual

6. Install a 1/4 inch copper water line (not supplied with unit) from
the nearest COLD water pipe. When connecting the water supply,
follow these guidelines:
• Review the local plumbing codes before you install the unit.
• In most instances, the cold water supply will come from the
basement through a hole in the floor.
• The water pressure should be 20-120 psi.
NEVER use an extension cord to connect
power to the unit.
Electrical Grounding Required. This appliance
is equipped with a three prong (grounding)
polarized plug for your protection against pos-
sible shock hazards.
Never remove the round grounding prong from
the plug.
Never use a two-prong grounding adapter.
Where a two-prong wall receptacle is encoun-
tered, contact a qualified electrician to have it
replaced with a three-prong receptacle in accordance with
applicable electrical codes.
!
WARNING
!
!
WARNING
!
9
UL124
DOOR
SWING
CABINET
OR WALL
0"
CLEARANCE
NEEDED
NOTE
Keep in mind that the
door of the unit may be
mounted on either side
of the cabinet (see
REVERSING THE
DOOR). All U-Line units
have a zero clearance
for the door to open
(see Figure 2).
Figure 2

U-Line CLR60 Specifications

General

Brand	U-Line
Model	CLR60
Category	Ice Maker
Language	English