U-Line CLR60 User Manual

ADJUSTING ICE THICKNESS
The ice thickness control is set to
automatically maintain an ice
bridge of 0.16-0.32 cm (1/16-
1/8 inch) thick. A dimple in each
cube is normal (see Figure 28). If
an adjustment is needed, per-
form the following steps:
Do not touch electrical wires. Disconnect
power to the ice maker before making any ice
thickness adjustments.
1. Disconnect power from the unit.
2. Remove front access panel (2 screws).
3. Locate the ice thickness adjustment dial on the control board (see
Figure 29).
Figure 29
UL318A
DIAL IS FACTORY
SET TO +1
ICE THICKNESS
ADJUSTMENT 
DIAL
0
1
2
3
4
5
-5
-4
-3
-2
-1
0
1
2
3
4
5
-5
-4
-3
-2
-1
!
WARNING
!
22
User’s Manual
ICE BRIDGE SHOULD BE
1/16 - 1/8 INCH THICK
A DIMPLE IN EACH
CUBE CELL IS NORMAL
UL250
Figure 28

U-Line CLR60 Specifications

General

Brand	U-Line
Model	CLR60
Category	Ice Maker
Language	English