Figure 27
NORMAL OPERATION
The ice maker is designed to make clear ice from most water sources
on a consistent basis. Water is constantly circulated over the evapo-
rator assembly. As the water freezes, gravity causes any sediment to
drop into the water trough and not become imbedded in the ice. This
gives a clearer ice cube with a low mineral content.
When the ice reaches the desired thickness, it falls off the evaporator
and into the storage bin. The cycle is then repeated. When the level
of ice reaches the top of the storage bin the unit shuts off. As the ice
level in the bin drops the unit will automatically restart to keep the bin
full.
Your unit’s ice production rate may vary depending on many consider-
ations. Ambient air temperatures, water temperatures, condenser
cleanliness and ice-maker cleanliness are all contributing factors to how
quickly the unit produces ice.
Certain sounds are normal during the unit’s operation. You may hear
the compressor or fan motor, the water valve, the water circulation
pump or ice dropping into the ice storage bin.
NOTE
The cycle selector switch is
recessed behind the front
grille. An opening is pro-
vided in the grille to access
the switch (see Figure 27).
To Next Page
Loading...
Need help?
General