EasyManua.ls Logo

U-Line H-5819 - AUTO POWER-OFF AND MAINTENANCE; TROUBLESHOOTING GUIDE; ERROR CODES AND RESOLUTIONS

U-Line H-5819
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PAGE 11 OF 33 0819 IH-5819
AUTO POWER-OFF
When the auto power-off time is enabled, the scale will
automatically turn off when there has been no load on
the platform and the scale is stable at zero position for a
specified period of time in minutes. At startup, the scale
will automatically turn off after five minutes.
1. Turn on the scale and press the TARE key
Tare
during
the self-test. PO CAL will be shown on the display.
PO CAL
2. Press the TARE key
Tare
until P13 SP is shown on the
display.
3. Press the ZERO key
Zero
to enter the menu.
4. Press the TARE key
Tare
to change the setting.
Of 0 – Auto power-off is off.
Of 3 – Auto power-off at 3 minutes.
Of 5 – Auto power-off at 5 minutes.
Of 15 – Auto power-off at 15 minutes.
Of 30 – Auto power-off at 30 minutes.
5. Press the ZERO key
Zero
to select the new setting.
6. Press the
TARE key
Tare
to view additional menus or
press the MODE key
Mode
to exit the setup menu.
SETUP MENU CONTINUED
CLEANING
CAUTION! Disconnect the unit from the power
supply before cleaning.
Use a mild detergent for the display, keypad and
housing.
WARNING! Do not use solvents, chemicals,
alcohol, ammonia or abrasives.
Use a stainless steel cleaning solution for the stainless
steel platform.
Apply cleaner to a clean, damp cloth and wipe surface.
Dry thoroughly.
MAINTENANCE
TROUBLESHOOTING
OPERATING ISSUE / ERROR CODE CAUSE RECOMMENDATIONS
-OL- Maximum capacity exceeded. Remove load from the platform.
Bat lo
Blinking Display
Faded Display
Low Battery. Recharge the battery.
Err 4 Scale needs to be recalibrated. Recalibrate the scale.
FAIL Calibration did not work. Recalibrate the scale.
Load Lo Calibration weight is too light. Use calibration weight that is equal to or exceeds
minimum calibration weight.
Load Hi Calibration weight is too heavy. Use calibration weight that is equal to or less than
maximum calibration weight.
If the problem persists or the troubleshooting section does not resolve or describe your problem, contact
Uline Customer Service at 1-800-295-5510.
π
CHICAGO • ATLANTA • DALLAS • LOS ANGELES • MINNEAPOLIS • NYC/PHILA • SEATTLE • MEXICO • CANADA
1-800-295-5510
uline.com

Related product manuals