PAGE 8 OF 33 0819 IH-5819
5. Add additional items to platform. New data will be
added to memory. Continue until all data is added.
6. To recall data and clear data, see sections above.
UNIT WEIGHT MEMORY
The scale can store and recall up 255 unit weights.
SETTING A UNIT WEIGHT
1. Key in the unit weight by using the numeric keys.
2. Press and hold the PLU key
PLU
. PLU will be shown
on the display.
3. Key in the unit weight name using the numeric keys.
Names should be three digits between 001 and 255.
4. Once keyed in, SAV### will be shown on the
display. The scale makes a beeping sound and
enters the counting mode.
RECALLING A UNIT WEIGHT
1. Place items to be counted on the platform.
2. Press the PLU key
PLU
. PLU will appear on display.
3. Key in the three digit unit weight name by using the
numeric keys.
PL### will be shown on the display.
4. Scale will recall the unit weight and then display the
number of items on the platform.
RS-232
1. Specifications:
• RS-232 output of weighing data
• ASCII CODE
• 600-9,600 Baud
• 8 data bits
• No Parity
2. RS-232 (9-pin d type connector)
Pin 2 RXD Input Receiving Data
Pin 3 TXD Output Transmission Data
Pin 5 GND — Signal Ground
9 Pin D Connector
Scale Computer/Printer
Pin 2: Pin 3
Pin 3: Pin 2
Pin 5: Pin 5
NOTE: If data is not getting in your computer/
printer, interchange pin 3 and pin 2 connections.
3. Continuously output protocol.
CONT: WEIGHING MODE
S T ， G S
4. OD-2130D Printer Formats:
ENABLE WEIGHING UNITS
At startup, all weighing units are enabled – lb / oz / g / kg.
Enter this menu to change enabled weighing units.
NOTE: lb. weighing unit cannot be turned off.
1. Turn on the scale and press the TARE key
Tare
during
the self-test. PO CAL will be shown on the display.
PO CAL
2. Press the TARE key
Tare
until P3 Unt is shown on the
display.
3. Press the ZERO key
Zero
to enter the menu.
4. kg
will be shown on the display. Press the TARE key
Tare
to select on or off. Press the ZERO key
Zero
to select
the new setting.
5. g
will be shown on the display. Press the
TARE key
Tare
to select on or off. Press the ZERO key
Zero
to select
the new setting.
6. oz
will be shown on the display. Press the TARE key
Tare
to select on or off. Press the ZERO key
Zero
to select
the new setting.
7. Press the
TARE key
Tare
to view additional menus or
press the MODE key
Mode
to exit the setup menu.
OPERATION CONTINUED
To Next Page
Loading...
