Ubee DDW3612 - Default Values

1.1 Device Overview Ubee Interactive
4 DDW3612 Subscriber User Guide • July, 2010
 Operating Temperature: 0°C ~ 40°C
 Humidity: 5~90% (non-condensing)
1.1.3 Default Values
This device is pre-configured with the following parameters:
Local Port Address: 192.168.0.1, Web Interface: http://192.168.0.1
Operation Mode: NAT Mode (WAN setting)
Subnet Mask: 255.255.255.0
Wireless Defaults:
 Primary SSID (subscriber-managed) = DDW3612 plus last 2 characters of the
cable modem’s MAC Address (UPPER case, if letters).
Example: DDW3612BE
Note: If the subscriber changes the SSID, the device does not revert to this default
SSID upon any reset of the device, except in the case of a manual reset to restore
factory default settings. The device MAC address can be found on the device
label, or refer to Cable Modem - Information (p. 12).
 WPA Pre-shared Key = DDW3612 plus the last 6 characters (3 octets) of the
cable modem’s MAC address.
Example: DDW36127CD4BE
 WPS PIN = 12345670
 Device Name = UbeeAP
Web Interface Logins (also used for telnet access):
Standard User/Consumer Web Interface Login:
Username: user
Password: user