ODIN-W2 series - Getting Started
UBX-15017452 - R02 Advance Information Evaluation board
Page 11 of 27
4.2 Restore default serial settings
If the Restore/Function button is pressed during power on, the module resets the serial settings and escape
sequence to the default values.
• Default serial settings is 115.2 kbps, 8N1 and HW flow control enabled
• Default escape sequence is +++
• Default escape sequence timing is 1s silence before and after escape sequence
4.3 Restore factory settings
If both the default serial settings and the external connect button is pressed during power on, the factory
settings are restored. You can also restore to factory settings using the AT+UFACTORY command followed by
power off/on.
To Next Page
Loading...
