Ublox ODIN-W2 Series - Set a Default Remote Peer (Wi-Fi and TCP) Using DHCP and Connect at Startup

ODIN-W2 series - Getting Started
UBX-15017452 - R02 Advance Information Use case examples
Page 18 of 27
7.3 Set a default remote peer (Wi-Fi and TCP) using DHCP and connect
at startup
• Alternative 1 - Network part using DHCP
o AT+UWSCA=0,4
 Deactivate network id 0
o AT+UWSC=0,0,1
 Active on startup
• Wi-Fi part
o AT+UWSC=0,2,"my ssid"
 Set the Network SSID to connected to
o AT+UWSC=0,5,2
 Use WPA2 as authentication type
o AT+UWSC=0,8,"my password"
 The secret WPA2 Password
o AT+UWSCA=0,1
 Store Wi-Fi configuration
• TCP and data part
o AT+UDDRP=0,"tcp://192.168.0.100:8080",2
 Set default remote peer id 0, using tcp and always connected
o AT+UMSM=1
 Set startup mode to data mode
• Restart module for settings to take effect
o AT&W0
 Store configuration to startup database
o AT+CPWROFF
 Reboot and ODIN-W2 will now:
1. Start to scan for the network with the SSID = "my network"
2. When Wi-Fi is connected and the Network is up, the TCP
connection will be set up as well