Ublox ODIN-W2 Series - Internal Antenna Placement; Power Supply Interface Design; Module Power Supply Design

ODIN-W2 series - Getting Started
UBX-15017452 - R02 Advance Information Use case examples
Page 24 of 27
7.6 Connect two ODIN-W2 using Bluetooth Low Energy Serial Port
Service SPS and always connected
To set up first ODIN-W2 as a Central (Device A)
• AT+UBTLE=1
o Enable Central Role
• AT+UDSC=1,1
o Set server config id 1 to Serial Port Service
• AT+UMSM=1
o Boot ODIN-W2 in data mode
• AT&W
o Store config
• AT+CPWROFF
o Restart ODIN-W2
To set up second ODIN-W2 a Peripheral (Device B)
• AT+UBTLE=2
o Enable Peripheral Role
• AT+UDDRP=1,sps://112233445566,2
o Default peer to Serial Port Service and always connected
• AT+UMSM=1
o Boot ODIN-W2 in data mode
• AT&W
o Store config
• AT+CPWROFF
o Restart