UCHIDA AeroCut - 2 Operating Instructions; Checks before Use; Setting of Stacker

2. Operating instructions
(1) Checks before use
Check the following before operation.
① Is the electric power turned off?
② Is the feed table set?
③ Is the stacker set？
④ Is the electric power cord plugged in?
⑤ Is the waste box set?
(2) Setting of stacker
① Open the stacker and set the stays in the indentation of the back of the stacker at an
appropriate angle to allow smooth paper ejection.
② Adjust the large paper guide according to the paper size.
Caution
Power it off. Otherwise,
Injury could occur.
Paper Guide (Large)
Stacker
Stay
Indentation
１１