cool-down the interior before you have to get in. You can
send a request to your vehicle in one of two ways:
• Using the Uconnect Access App from a compatible
device.
• From the Mopar Owner Connect website
(
moparownerconnect.com
).
You can also send a command to turn-off an engine that
has been remote started. After 15 minutes if you have not
entered your vehicle with the key, the engine will shut off
automatically.
This remote function requires your vehicle to be
equipped with a factory-installed Remote Start system.
If you want, you can set-up notifications for your account
to receive an email or text (SMS) message every time a
command is sent to remote start or cancel a remote start.
How It Works
Uconnect Access App:
1. Download the Uconnect Access App to a compatible
device and login using your username and password.
2. To start the engine, press the “circular arrow”, to
turn-off an engine that has been remote started press
the “cancel” button.
3. A pop-up screen will appear asking for your Uconnect
Security PIN (this is the same 4-digit code established
when your registered your Uconnect Access system).
Enter the Uconnect Security PIN on the keypad and
press “OK.”
4. The Uconnect Access App will confirm if your com-
mand was sent (or not). Press “OK” to close the
pop-up screen.
64 ALL ABOUT UCONNECT ACCESS
To Next Page
Loading...
Need help?
General
