3. A pop-up screen will appear asking for your
Uconnect® Security PIN (this is the same 4- digit code
established when your registered your Uconnect®
Access system). Enter the Uconnect® Security PIN on
the keypad and press “OK.”
4. The Uconnect® Access App will confirm if your
command was sent (or not). Press “OK” to close the
pop-up screen.
5. It will take a little while for the command to go
through to your vehicle. The time it takes depends on
a number of technical conditions.
6. A message will appear on the screen to let you know
if the command was received by your vehicle.
Mopar Owner Connect website:
1. Log on to the Mopar Owner Connect website
(
moparownerconnect.com
) using the username and
password you used when registering your Uconnect®
Access system.
NOTE: If you forgot your username or password, links
are provided on the website to help you retrieve them.
110 ALL ABOUT Uconnect® ACCESS
To Next Page
Loading...
