To Send A Text Message:
1. Push the Uconnect® Phone button,
2. Wait for the beep,
3. Say “Text.”
4. Uconnect® will prompt you “Say the phone number,
or full name and phone type of the contact you want
to send a message to.”
5. Wait for the beep and say a contact that is in your
phonebook, or a mobile phone number that you
would like to send the message to.
6. Uconnect® will prompt you “Please say the message
that you would like to send” (If you do not hear this
prompt, you may not have an active subscription with
Uconnect® Access).
7. Wait for the beep, and then dictate any message up to
140 characters. If you exceed 140 characters, you will
hear the following prompt: “Message was too long;
your message will be truncated.”
8. Uconnect® will then repeat the message back to you.
9. Uconnect® will prompt you: To add to your message,
say “Continue”; to delete the current message and
start over, say “Start Over”; to send the current
message, say “Send”; to hear the message again, say
“Repeat.”
10. If you are happy with your message and would like
to send it, wait for the beep and say “Send.”
11. Uconnect® will then say “Sending your message.”
4
Uconnect® 8.4AN — If Equipped 337
To Next Page
Loading...
