EasyManuals Logo

UFactory LITE 6 User Manual

UFactory LITE 6
165 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #51 background imageLoading...
Page #51 background image
1.2.2 IP Configuration
Before connecting the robotic arm with UFACTORY Studio (communication
with the robotic arm), make sure that the IP address of the computer and
the IP address of the control box are on the same network segment. When
the control box is shipped from the factory, the default IP address is
192.168.1.xxx (The factory IP address of the device has been marked on
the base of the robot). Therefore, to successfully communicate with the
control box, the IPV4 network segment on the computer must be between
192.168.1.2-192.168.1.255 (cannot be the same as the IP address tail
number of the control box).
IP Setting
Network and Sharing Center Ethernet Properties IPV4
Step1: Open the “Network and Sharing Center”

Other manuals for UFactory LITE 6

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the UFactory LITE 6 and is the answer not in the manual?

UFactory LITE 6 Specifications

General IconGeneral
BrandUFactory
ModelLITE 6
CategoryRobotics
LanguageEnglish

Related product manuals