UFactory LITE 6 - End-Effector I;O

1. Interfering signals above the level specified in
the IEC standard will cause abnormal behaviour
of the robotic arm. Extremely high signal levels
or excessive exposure can cause permanent damage
to the robotic arm. UFACTORY (Shenzhen)
Technology Co., Ltd. is not responsible for any
loss caused by EMC problems.
2. The length of the I/O cable that used to connect
the Control Box with other mechanical and plant
equipment must not exceed 30 meters unless it is
feasible after the extension testing.
1. When wiring the electrical interface of the
Control Box, the Control Box must be powered off.
2.2. End-Effector I/O
At the tool side of the robotic arm, there is an avionic socket 8-pin