31
When you have multiple spools of material in use, or do not print with a material, it is very important that you store them
properly. If material is stored incorrectly, it may affect its quality and usability.
To keep your materials in optimal condition it is important that you keep them:
• Cool and dry
• Out of direct sunlight
• In a resealable bag
The optimal storage temperature for PLA, Nylon, CPE, CPE+, PC, PP, and TPU 95A is between -20 to +30° C. For ABS the
advised temperature is between 15 and 25° C. A relative humidity of below 50% is recommended for PP and TPU 95A. If
these materials are exposed to a higher humidity the quality of the material can be affected. You can store the material in a
resealable bag, including the supplied desiccant (silica gel).
Storage and handling of materials
To Next Page
Loading...
