EasyManuals Logo

Ultimaker 2+ Calibration Guide

Ultimaker 2+
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Ultimaker 2+, 2+ EXT - Calibration Guide
Written By: Adalyn Ordono
Ultimaker 2+, 2+ EXT - Calibration Guide
2020-07-23[major]
v1.0
Release:Guide ID: 127 -
This document was generated on 2021-12-22 12:23:35 AM (MST).
© 2021 support.mosaicmfg.com/ Page 1 of 9

Other manuals for Ultimaker 2+

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ultimaker 2+ and is the answer not in the manual?

Ultimaker 2+ Specifications

General IconGeneral
Build Volume223 x 223 x 205 mm
Layer Resolution20 - 200 microns
Print TechnologyFused Filament Fabrication (FFF)
Filament Diameter2.85 mm
Print Speed30 - 300 mm/s
ConnectivityUSB, SD Card
Weight11.3 kg
Nozzle Diameter0.4 mm
Supported MaterialsPLA, ABS, CPE
DisplayLCD
SoftwareCura
Power Supply100 - 240 VAC, 50 - 60 Hz
Operating Temperature15 - 32 °C
Dimensions342 x 588 mm

Related product manuals