Ultimaker 2+ - Introduction

Step 9 — Start Print
Start the print on the Ultimaker screen by navigating to Print > Select the calibration print. If you
get a message 'This print job is not suitable for this printer…', select 'Ignore'. Please note the
printer may take 5-6 minutes to initialize. It will start automatically after this.

Ultimaker 2+, 2+ EXT - Calibration Guide
2020-07-23[major]
v1.0
Release:Guide ID: 127 -
This document was generated on 2021-12-22 12:23:35 AM (MST).
© 2021 support.mosaicmfg.com/ Page 9 of 9