Ultimaker 2+ - Step 1 - Enter the Outgoing Tube Length on Palette

Step 1 — Enter the Outgoing Tube Length on Palette
On Palette screen navigate to Next > Other and then select 'Custom' and then using the arrows,
change the amount to the length to 102cm. If you don’t see 'Next' select Settings > Preferences >
Outgoing Tube Length select 'Custom' and then using the arrows, increase the amount to the
length indicated in the chart above.

Note: Tube length is printer type specific. The tube lengths in the chart above should be set in
Palette when you are using the corresponding UM printer. If you switch your Palette to another
printer, ensure that you set the tube length back to the appropriate tube length that you have set
up for that printer.

Ultimaker 2+, 2+ EXT - Calibration Guide
2020-07-23[major]
v1.0
Release:Guide ID: 127 -
This document was generated on 2021-12-22 12:23:35 AM (MST).
© 2021 support.mosaicmfg.com/ Page 3 of 9