Ultimaker METHOD XL User Manual

ULTIMAKER METHOD XL MANUAL PAGE 14
STARTER KIT
Inside the box of your UltiMaker Method XL, you will nd almost everything you need to get started, including both a Model
Performance Extruder and Support Performance Extruder, a spring steel build plate, a leveling hex key, a nozzle cleaning
brush, and two power cords (North America and EU). To order material, visit store.makerbot.com.
Spring Steel Build Plate
Model Performanc
Extruder
Support Performanc
Extruder
Nozzle Removal Tool Nozzle Tubes Cleaning Brush
Spatula Flush Cutters
Leveling and Nozzle
Replacement Keys
Guide Tubes
North America 
EU Power Cords
SETTING UP THE METHOD XL
CAUTION:
Never remove a Performance Extruder from your UltiMaker Method XL 3D printer during or
immediately after printing. Always allow a Performance Extruder to cool below 50°C.
In case of con  icting information between this Manual and the on - screen instructions, F O LL OW T H E O N - SCREEN
information, since it is updated more fre q uently.
TURN ON Y OUR ULTIMAKER METHOD XL
The power button for the UltiMaker Method XL is located on the top front panel, to the left of the USB port. Push this button
to turn on your UltiMaker Method XL.
PO W ER B UTTON

Ultimaker METHOD XL Specifications

General

Brand	Ultimaker
Model	METHOD XL
Category	3D Printers
Language	English