Your safety and the safety of others are very important. Always read and obey all safety
messages.
These are the safety alert symbols used to alert you to potential hazards. All safety messages will follow the
safety alert symbol and either the word "WARNING" or "CAUTION". These words mean
WARNING: You can be seriously injured if you don't follow instructions
CAUTION: You can be exposed to a potentially hazardous situation which, if not avoided, may result in minor or
moderate injury
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and
tell you what can happen if the instructions are not followed.
WARNING:
The UltiMaker Method XL includes moving parts that may cause injury. Never reach inside the
UltiMaker Method XL while it is in operation.
WARNING:
The UltiMaker Method XL generates high temperatures. Always allow the UltiMaker Method
XL Performance Extruders to cool down before you reach inside.
WARNING:
There is a risk of shock. The electronics of the UltiMaker Method XL are not user serviceable.
CAUTION
The socket outlet must be located near the printer and must be easily accessible.
CAUTION:
Plug directly into a socket outlet. If an extension cord is required, only use a properly rated
cord with a 15A minimum rating.
CAUTION
In case of emergency, disconnect the UltiMaker Method XL from the socket outlet.
CAUTION:
The UltiMaker Method XL melts plastic during printing. Plastic odors and particles may be
emitted during this operation. Make sure to set up the UltiMaker Method XL in a well-
ventilated area.
CAUTION:
Always allow the Performance Extruders to cool to 50°C before reaching inside the UltiMaker
Method XL or removing the Performance Extruders.
CAUTION
Children under 1
2
should be supervised by an adult.
CAUTION:
D
ust generation and accumulation should be minimized.
S
ome dust and dry powders can
build static electricity charges when subjected to friction and create an ignition hazard.
NOT
E
:
F
or users in
J
apan, the power cord is only for use with this printer model, UltiMaker Method
XL.
ULTIMAKER METHOD XL MANUAL PAGE 9
To Next Page
Loading...
Need help?
General
