UNI-T UT60F User Manual

29
I. Model UT60 G: Temperature Measurement
(see figure 11)
Warning
To avoid harms to you, please do not attempt to
measure voltages higher than 60V DC or 30V rms AC.
( figure 11)
The temperature measurement range is -40
o
C~1000
o
C.
To measure temperature, connect the Meter as follows:
1. Insert the red temperature probe into the mA
o
C terminal
and the black temperature probe into the COM terminal.
2. Set the rotary switch to
o
C;
3. Place the temperature probe to the object being
measured.
The measured value shows on the display.
Note
l The Meter automatically displays the temperature
value inside the Meter when there is no temperature
probe connection.
l The included point contact temperature probe can
only be used up to 250
o
C. For any measurement
higher than that, the other type temperature probe
must be used instead.
l When temperature measurement has been completed,
disconnect the connection between the temperature
probe and the circuit under test, and remove the
temperature probe away from the input terminals of
the Meter.
Measurement Operation(13)
Model UT60F/G: OPERATING MANUAL

UNI-T UT60F Specifications

General

Brand	UNI-T
Model	UT60F
Category	Multimeter
Language	English