Operation of Auto Hold Mode
Auto Hold means you no need to press HOLD, the
readings on the LCD will be hold automatically.
Conditions to enter Auto Hold Mode:
l When input signal is larger than AC/DC 100mV,
Auto Hold mode will be enabled automatically.
l When the change of signal three times continuously
within
3 digits, it will hold the last value; the Meter
beeps.
l Considers every value as the base value. When
the Meter detects an input which is above the base
value
300 digits, the Meter beeps, and holds and
displays the value as the new base value.
Model UT70C: OPERATING MANUAL
32
To Next Page
Loading...
