UTD2000 Series User Manual
19
Figure 2-6 Probe Attenuation Coefficient Setting in Channel Menu
2.4 Vertical Volts/Div adjustment setting
Adjustments of vertical deflection factor V/div gear position can be set to coarse
adjustment and fine adjustment.
For coarse adjustment, V/div can be adjusted in step of multiple of 1, 2 and 5, the V/div
range is 1mV/div～20V/div.
Fine adjustments refer to changing deflection factor with smaller stepping within the
current vertical gear position range. Vertical deflection factor can be consecutively adjusted
within all vertical gears.
Figure 2-7 Coarse and Fine Adjustment of Vertical Deflection Factors
2.5 Settings of waveform inverting
Waveform inverting can be set by F5 function button. The measured input signal will
be displayed with 180 degrees difference. Please see Figure 2-8 for a non-inverted
waveform and Figure 2-9 for an inverted waveform.
Figure 2-8 Vertical Channel Inverted Settings (Invert: OFF)
To Next Page
Loading...
