Name: UNI-T UTD2000 Series
Brand: UNI-T
Rating: 5 (1 reviews)

To Previous Page

UTD2000 Series User Manual

guarantee on the product's tradability and suitability for any specific purpose. Under no

circumstance will UNI-T bear any liability for any indirect, special or subsequent loss.

Appendix D Contact Us

For product support outside China, contact your local UNI-T supplier or sales centre.

Service Support: Many UNI-T products offer optional plans of extended warranty period or

calibration period. For details please contact your local UNI-T supplier or sales centre.

Guaranty and Declaration2
General Safety Overview4
Safety Terms and Symbols5
Preface6
Table of Contents8
Contents8
Chapter I Introductions10
- General Inspection10
- Function Inspection10
- Front and Rear Panel12
- Display13
- Automatic Settings of Waveform Display13
- Introduction to the Vertical System13
- Introduction to the Horizontal System14
- Introduction to the Trigger System15
Chapter II Vertical System16
- Setting Coupling Channel17
- Setting Channel Bandwidth Limited18
- Setting Probe Rate18
- Vertical Volts/DIV Adjustment Setting19
- Settings of Waveform Inverting19
- Mathematical Operation Function20
- FFT Spectral Analysis21
Chapter III Horizontal System23
- Horizontal Control23
- Explanation of Nouns23
- Window Extension24
- Trigger Hold-Off Time Adjustment24
Chapter IV Trigger System26
- Edge Trigger26
- Pulse Width Trigger27
- Video Trigger29
- Alternating Trigger30
- Explanation of Nouns32
Chapter V Acquire System34
Chapter VI Display System36
- XY Mode36
Chapter VII Measurement Parameters37
- Measurement Menu37
- Voltage Parameter38
- Time Parameter38
Chapter VIII Cursor Measurement40
Chapter IX Storage and Load System41
- Setup Storage and Load41
- Waveform Storage and Load42
- Bit Map Storage and Load43
- Screen Copy43
Chapter X Utility System44
- Pass/Fail45
- Recorder46
Chapter XI Other Funtion Botton48
- Auto48
- Run/Stop48
- Help Menu49
- Upgrade Program49
Chapter XII Applicaion Example50
- Example 1: Measuring Simple Signals50
- Example 2: Observing the Delay Caused by a Sine Wave Signal Passes through the Circuit50
- Example 3: Acquiring Single Signals51
- Example 4: Reducing Random Noise of Signals52
- Example 5: Using the Cursors for Measurement53
Chapter XIII System Prompts and Trouble-Shooting55
- Definitions of System Prompts55
- Troubleshooting55
Chapter XIV Technical Information57
Chapter XV Appendix62
- Appendix A Accessories of UTD2000 Series62
- Appendix B Maintenance and Cleaning62
- Appendix C Warranty62
- Appendix D Contact Us63

Brand	UNI-T
Model	UTD2000 Series
Category	Test Equipment
Language	English

UNI-T UTD2000 Series User Manual

Table of Contents

Questions and Answers:

UNI-T UTD2000 Series Specifications

Related product manuals