Name: UNI-T UTG1000 Series
Brand: UNI-T
Rating: 4 (1 reviews)

To Next Page

To Previous Page

26 UTG1000A Series

3) Set Carrier Wave Signal Parameter

Press Carrier Wave Parameter→Type→ Square Wave in turn to select square wave as carrier wave signal.

Press Parametersoftkey again, and the interface will pop up as following:

Press corresponding softkey, then enter required numerical value, and select the unit.

Questions and Answers:

Need help?

Do you have a question about the UNI-T UTG1000 Series and is the answer not in the manual?

UNI-T UTG1000 Series Specifications

General