UNI-T UTG1000 Series User Manual

UTG1000A Series 67
4.2 Sweep Waveform Output
In sweep mode, frequency is output in linear or logarithmic way during the specified sweep time. Trigger source can
be internal, external or manual trigger; and sine wave, square wave, ramp wave and arbitrary wave (except DC) can
produce sweep output.
4.2.1 Sweep Selection
1) Enable Sweep Function
Press Menu button first, then press Sweepsoftkey to start sweep function. The device will output sweep waveform
with current setting.
2) Sweep Waveform Selection
Press Carrier Parametersoftkey to select sweep waveform, then the interface popping up will show as following:

UNI-T UTG1000 Series Specifications

General

Brand	UNI-T
Model	UTG1000 Series
Category	Portable Generator
Language	English