UniCarriers 1F2 - LPG Remaining Time Management

49
LPG REMAINING TIME MANAGEMENT
This function is not part of the LPG Level Warning/LPG Rack
Lock Warning system.
With this function the operator sets the time interval between LPG
Cylinder (tank) replacements. Then, when the time reaches zero (0), this
function illuminates the LPG level warning symbol and the multipurpose
warning light to warn the operator of the need to replace the LPG
Cylinder (tank). For the method used to change the LPG level warning
pattern to the method above, contact your Local Authorized Dealer.
LPG remaining time management is recommended for the following
types of situations:
• The timing for replacement of the LPG Cylinder (tank) is
predetermined.
• The LPG level warning appears too early or too late on the lift truck.
CAUTION
!
• Set a time that leaves a sufcient amount of leeway.
• After replacing the LPG Cylinder (tank), be sure to set the
time setting again. Otherwise, the time setting continues
after LPG Cylinder (tank) replacement, and this may result in
the LPG level warning symbol turning on at an unintended
time.
• When operating a dual fuel lift truck using gasoline after
using LPG without the time setting, be careful that the time
setting continues to count the time.
LPG Remaining Time Setting
• When the time setting is set to , the meter panel shows the
LPG level warning .
• When the time setting is reset, move the setting display by pushing
, and while the LPG level warning is displayed. After
resetting the setting time, the LPG level warning turns off.
FR
CH
N
00.0