PERIODIC INSPECTIONPERIODIC INSPECTION
4-134-13
11
22
33
44
55
66
■■
LUBRICATING LIFT CHAINLUBRICATING LIFT CHAIN
Apply Apply engine engine oil oil to to the the lift lift chains chains using using a a lubricator lubricator oror
brush. To allow oil to enter between each pin and linkbrush. To allow oil to enter between each pin and link
plate of the lift chain, observe the following conditions:plate of the lift chain, observe the following conditions:
•• Lower the forks Lower the forks on the ground and loosen on the ground and loosen the chainsthe chains
sufciently.sufciently.
••
After applying engine After applying engine oil, move oil, move the mast up the mast up and downand down
fully at least 10 times.fully at least 10 times.
NOTENOTE
If your lift truck is used near a port or coastal area,If your lift truck is used near a port or coastal area,
the lift chains might be damaged by salty breeze.the lift chains might be damaged by salty breeze.
After a storm or typhooAfter a storm or typhoon, it is advisable tn, it is advisable to wash themo wash them
with fresh water before lubricating in the mannerwith fresh water before lubricating in the manner
described above.described above.
■■ APPLYING GREASE ON THE MASTAPPLYING GREASE ON THE MAST
WARNINGWARNING
Do not climb the mast. Do not put your handDo not climb the mast. Do not put your hand
or foot on the connecting members or into theor foot on the connecting members or into the
mast assembly. You might get injured if the mastmast assembly. You might get injured if the mast
moves moves accidentallyaccidentally..
1. SLIPPER1. SLIPPER
2. 2. END END ROLLERROLLER
3. 3. SIDE SIDE ROLLERROLLER
4. 4. INNER INNER CHANNELCHANNEL
5. 5. INTERMEDIATE INTERMEDIATE CHANNELCHANNEL
6. 6. OUTER OUTER CHANNELCHANNEL
Apply grease on the surfaces (hatched areas)Apply grease on the surfaces (hatched areas)
over which the end rollers, side rollers andover which the end rollers, side rollers and
slippers roll.slippers roll.
11
1 1 : : CHAINCHAIN
To Next Page
Loading...
