CAUTION PLATESCAUTION PLATES
1-371-37
2. 2. Precautions Precautions while while removing removing and and returningreturning
the batterythe battery
WARNING WARNING
••
Never place yourself between Never place yourself between the battery and the battery and mast or mast or trucktruck
body.body.
•• Make sure to Make sure to remove and return remove and return the battery back the battery back with thewith the
truck parked on a level surface and in an area with notruck parked on a level surface and in an area with no
obstacles in front.obstacles in front.
•• Keep the forks at a height Keep the forks at a height of 10 to 30 cm and of 10 to 30 cm and be sure thebe sure the
truck is unloaded.truck is unloaded.
••
Make sure the Make sure the key switch is "OFF", key switch is "OFF", the forks are the forks are lowered tolowered to
the ground or floor surface and the battery connectors arethe ground or floor surface and the battery connectors are
disconnected before inspecting the battery, adding batterydisconnected before inspecting the battery, adding battery
electrolyte or water, or replacing electrolyte or water, or replacing the battery.the battery.
••
When returning When returning the battery the battery back, make surback, make sure that the e that the battery isbattery is
housed securely in the battery case and that the battery cablehoused securely in the battery case and that the battery cable
is not twisted, kinked or caught in the battery case or the truckis not twisted, kinked or caught in the battery case or the truck
body.body.
Removing and returning battery backRemoving and returning battery back
•• Pulling the Pulling the battery obattery out of ut of the trthe truckuck
1. 1. Retract the mast fuRetract the mast fully backward and press the lly backward and press the battery lockbattery lock
release pedal fully.release pedal fully.
2. 2. With the battery lock release pedal pressed, push theWith the battery lock release pedal pressed, push the
reach lever. The battery will come out as the mastreach lever. The battery will come out as the mast
advances.advances.
••
Putting tPutting the bathe battery batery back in ck in placeplace
1. 1. Press the battery lock release pedal fullyPress the battery lock release pedal fully, and then pull the, and then pull the
reach lever to retract the mast fully. The battery case willreach lever to retract the mast fully. The battery case will
be returned to its original position by the mast movement.be returned to its original position by the mast movement.
2. When the battery is returned back, the battery cable2. When the battery is returned back, the battery cable
might be twisted, kinked or caught in the battery case ormight be twisted, kinked or caught in the battery case or
the truck body. If this happens, put the battery cable in itsthe truck body. If this happens, put the battery cable in its
proper place and then put the battery case back in place.proper place and then put the battery case back in place.
3. 3. Make sure Make sure the mast is the mast is fully retracted.fully retracted.
Battery inspection and adding electrolyte or water should beBattery inspection and adding electrolyte or water should be
performed with the battery case pulled out and the batteryperformed with the battery case pulled out and the battery
connectors disconnected.connectors disconnected.
27E49-1230127E49-12301
3. 3. Precautions Precautions while while operating operating thethe
trucktruck
4. 4. How How to to use use the the load load metermeter
6. 6. Do not Do not put youput your hand r hand or fooor foot ont on
the mastthe mast
7. 7. Do Do not not stand stand or or walkwalk
under raised forksunder raised forks
WARNING WARNING
Keep arms, legs, and hands inside theKeep arms, legs, and hands inside the
operator’s compartment while traveling oroperator’s compartment while traveling or
load handling; otherwise there is dangerload handling; otherwise there is danger
of being injured due to entanglement andof being injured due to entanglement and
other types of accidents.other types of accidents.
27E49-1240127E49-12401
CAUTION CAUTION
Load meter can operate inLoad meter can operate in
the range of free-lifting.the range of free-lifting.
57B06-A271157B06-A2711
5. 5. Caution Caution to be to be taken taken when when using using the the side-shifterside-shifter
WARNING WARNING
CAUTION TO BE TAKEN WHEN USING SIDE SHIFTERCAUTION TO BE TAKEN WHEN USING SIDE SHIFTER
* Make sure the center of the load is aligned with the center of the* Make sure the center of the load is aligned with the center of the
truck before operating hydraulic controls or traveling with load.truck before operating hydraulic controls or traveling with load.
* Do not operate side shifter with the forks raised high (150 cm or* Do not operate side shifter with the forks raised high (150 cm or
higher), excluding when the load can be stabilized as it is over thehigher), excluding when the load can be stabilized as it is over the
shelf.shelf.
* * Do not operate side shifter during travDo not operate side shifter during traveling. Do not jerk side shiftereling. Do not jerk side shifter..
* * Make sure the bottom of forks is clear of ground or shelf surface.Make sure the bottom of forks is clear of ground or shelf surface.
* Do not use side shifter for purposes other than specified. Do not* Do not use side shifter for purposes other than specified. Do not
shove loads with side shove loads with side shifter.shifter.
61F16-1270161F16-12701
To Next Page
Loading...
