USER'S
MANUAL
Battery Information
Your
pager is designed
to
operate with a single AA-size alkaline battery (carbon
zinc batteries are not recommended). See the diagram on the following page
for
the battery door location.
To
install
or
replace the battery, place the pager face down and proceed as
follows:
0 Unlock the battery door
by
sliding the door latch away from the battery door.
8 Slide the battery door in the direction
of
the arrow (toward the outer edge).
6)
Lift the battery door away from the housing to remove it. Lift the battery
out
of
the battery compartment, taking note
of
the positive(+) and negative
(-)mark
ings on the battery and the pager housing.
Noticer Pager Battery
Replacement (rear view)
To
install a
new
battery, reverse this procedure, taking note
of
the positive(+)
and negative (-) markings.
23
To Next Page
Loading...
