Uniden BC296D - Using the Backlight; Dimmer Light Setting; Dimmer Time Setting; Controlling How Much Information Appears

Using the Backlight
To turn on the backlight, press . The next two sections
describe how to change the backlight options.
Dimmer Light Setting
The Dimmer Light setting sets the brightness of the display
backlight.
3:SYSTEM OPTION → 1:DIMMER →
1:DIMMER LIGHT
1:HIGH
Set the backlight to the brightest setting
2:MEDIUM
Set the backlight to be dimmer
Dimmer Time Setting
The Dimmer Time setting adjust how long the backlight stays
on when activated.
3:SYSTEM OPTION → 1:DIMMER →
2:DIMMER TIME
1:15SECONDS
Set the backlight to stay on for 15 seconds then turn
off
2:INFINITE
Set the backlight to stay on until you manually turn it
off.
Controlling How Much Information Appears
The scanner normally displays trunk, frequency, receiving
mode, and a signal meter when it is scanning. This option
allows you to reduce how much information your scanner
displays.
3:SYSTEM OPTION → 2:SCREEN MASK
1:ON
Display all information
2:OFF
Display reduced information
22
BC296D(NEW) 10/16/03 6:35 PM Page 22