Toggling End Code Detect
At the end of each transmission, a digital burst is sent so that
radios on the system will quickly switch back to the control
channel. Your scanner also listens for this code.
2:SCAN OPTION → 2:TRUNK → Select the bank
→ 0:END CODE
1:DETECT
The scanner detects the end code and immediately
switches back to the control channel.
2:IGNORE
The scanner waits for the carrier to drop before
switching back to the control channel.
53
BC296D(NEW) 10/16/03 6:35 PM Page 53
To Next Page
Loading...
